5 Minute FE

The FDI05M Forced Entry Resisting Door System is designed to provide 5 minutes of forced entry protection from a variety of tools.

Features

Provides 5 Minute Forced Entry Protection
Stanley CB199 NRP Hinge Preparation
Heavy duty 11-Guage steel construction
Door and frame shipped as a complete unit
Single vision, double vision, opaque

DOS Codes and Model Numbers

w/Vision - DOS 1141 GDT-05N-FDI-01
Opaque - DOS 2141 GDO-05N-FDI-01

Basic Use

Use this door system to provide protection in those applications where a forced entry threat exists. It is recommended that this door be used in conjunction with protected wall areas.

Limitations

This door has been designed to meet the 5-minute forced entry requirements as set forth in DOS SD-STD-01.01, Rev.G (amended). It is recommended that each end user determine the forced entry threat and choose the correct product to meet and resist that threat.

Construction

Doors and frames are constructed of 11-gauge steel components welded together. Each door will have 11 gauge vertical and horizontal steel stiffeners. Top and bottom of door are flush with face sheets.

Specifications

Door construction: Doors are constructed of steel plates, and steel tubes 1 ½” thick.

Door Frame Construction: Door frame assembly is constructed of steel tubes. Framing dimensions are 2” wide x 5” deep. Door frames are completely fabricated at factory and shipped with doors attached. All doors are pre-tested for all locking functions, clearances, and ease of operation, to ease field installation. All joint connections are welded to provide a rigid assembly when installed. The doorstop is built into the frame. Frames are predrilled to accept ½” anchors 12” on center. Shims are provided to take up a space at each anchor. Wiring diagrams are shipped enclosed in the hardware packages.

Hardware Assembly: Each door is equipped as follows:

Door Closer (LCN 4041 CUSH)
(2) Forced Entry Locks (Adams Rite 1850S w/ 15tt Thumbturns)
4 ea Stanley CB199 NRP 5” x 4 ½” concealed bearing hinges
Aluminum Threshold (Pemko 177AV36)
Weather Stripping (Pemko SS88D17)

Optional Hardware: Refer to the SHW group page for additional hardware information. You must select a lockset, pull handle, or panic device that suits your application. Most hardware is shipped pre-assembled with the door unit.

Subframes: To meet forced entry requirements of DOS SD.STD-01.01 (Rev. G amended), steel tube subframes ¼” wall thickness minimum, must be attached to concrete or masonry with Hilti® Epoxy Anchoring System. An acceptable alternative is the use of steel embeds, ½” thick minimum. These systems are included as options in our product line.

Finish: All doors and frames are furnished prime painted, ready for final finish in field. Options: Factory can apply polyurethane enamel; link to color chart is available on the main page. Doors can also be fitted with various types of architectural metals.

Glazing: Glazing materials shall be of a type approved by H.P. White Laboratory, Inc. for forced-entry resistance. Size to be limited to 20” x 30” vision area. Glazing is replaceable without removing the door from the frame.

Applicable Standard

DOS SD.STD-01.01 (Rev. G amended)

Weights and Measurements

Standard Door:

Door Thickness: 1 ¾”

Frame Thickness: 2” x 5”

Door Size: 36” x 84”

Frame Size: 40” x 86”

Rough Opening: 40 ½” x 86 ¼”

Shipping Weight: 900 lbs